 |
Providing responsible, courteous and SKILLED electrician services
since 1994.

Electricians Serving Your Area:
Connecticut Cities
Allingtown, CT
Ansonia, CT
Beacon Falls, CT
Bethany, CT
Bethel, CT
Botsford, CT
Branford, CT
Bridgeport, CT
Brookfield, CT
Cheshire, CT
Cos Cob, CT
Danbury, CT
Darien, CT
Derby, CT
East Haven, CT
Easton, CT
Fairfield, CT
Georgetown, CT
Greens Farms, CT
Greenwich, CT
Guilford, CT
Hamden, CT
Hawleyville, CT
Madison, CT
Meriden, CT
Middlebury, CT
Milford, CT
Monroe, CT
Naugatuck, CT
New Canaan, CT
New Fairfield, CT
New Haven, CT
Newtown, CT
North Branford, CT
North Haven, CT
Northford, CT
Norwalk, CT
Old Greenwich, CT
Orange, CT
Oxford, CT
Prospect, CT
Redding Ridge, CT
Redding, CT
Ridgefield, CT
Riverside, CT
Rowayton, CT
Sandy Hook, CT
Seymour, CT
Shelton, CT
Sherman, CT
South Britain, CT
South Norwalk, CT
Southbury, CT
Southport, CT
Stamford, CT
Stevenson, CT
Stony Creek, CT
Stratford, CT
Trumbull, CT
Wallingford, CT
Waterbury, CT
West Haven, CT
West Redding, CT
Weston, CT
Westport, CT
Whitneyville, CT
Wilton, CT
Wolcott, CT
Woodbridge, CT
Yalesville, CT

|
Toll free in CT: 877-723-9052
Safety Alert
Install Ground-Fault Circuit-Interrupter Protection for Pools, Spas and
Hot Tubs
CPSC Document #5039
The U.S. Consumer Product Safety Commission (CPSC) recommends
installing and using ground-fault circuit-interrupters (GFCIs) for
protection against electrocution hazards involving electrical
circuits and underwater lighting circuits in and around pools, spas,
and hot tubs.
CPSC is aware of more than a dozen electrocutions and a similar
number of electrical shock incidents involving circuits around
swimming pools between 1997 and 2002. Electrical incidents involving
underwater pool lighting were more numerous than those involving any
other consumer product used in or around pools, spas, and hot tubs.
The greater danger associated with electrical shock in a swimming
pool is that anyone in the pool may be rendered immobile and unable
to rescue themselves or to call for help. Drowning becomes a likely
outcome, even if the current is not immediately lethal. Bystanders
and would-be rescuers risk serious injury if the current flow isn't
stopped before they make contact with a conductive fixture, such as
a ladder, or enter the water to try to help a victim.
While grounding provides essential protection for pool, spa, and hot
tub equipment, GFCIs are the most effective means for protecting
people against electrical shock hazards of this nature.
A GFCI constantly monitors the flow of current through a protected
lighting fixture, pump motor or appliance circuit and senses any
loss of current to an outside path. If the current flowing into an
electrical appliance or fixture differs by a very small amount from
what flows |
back out, the GFCI instantly interrupts the current flow to prevent
a sustained, lethal level of electricity from reaching the consumer.
The consumer may feel a painful shock but should be protected from
electrocution.
The National Electrical Code (NEC) requires GFCI protection for
cord- and plug-connected pumps on pools, spas, and hot tubs;
120-volt underwater lighting fixtures; and receptacle outlets in the
vicinity of pools, spas and hot tubs. Today, the code prohibits
electrical installations closer than five feet from water and
requires GFCI protection for all electrical equipment, including
240-volt equipment located five to 10 feet from the water and for
receptacles within a 20-foot perimeter.
Older pools, spas and hot tubs may not have adequate GFCI
protection. In particular, pools older than 30 years may not have
GFCI protection on underwater lighting circuits. Because the NEC
provision for spas only became effective in 1981, even somewhat
newer spas or hot tubs may not be protected.
CPSC urges consumers to have an electrician who is qualified in pool
and spa repairs install adequate GFCI protection for all pool, spa,
and hot tub electrical equipment and for underwater swimming pool
lighting fixtures. Additionally, outdoor outlets that could
potentially be used to plug in electrical appliances (e.g., radios,
pumps, washers) used near the pool also should be equipped with GFCI
protection. Remember to test the GFCI regularly to be assured of
continued protection.
|
TO PREVENT ELECTROCUTION:
- Install GFCIs
- On underwater lighting circuits operating at more
than 15 volts.
On all electrical equipment used with pools, spas
and hot tubs, including heaters operated on 240-volt
circuits.
On all outdoor receptacles and any indoor
receptacles that could potentially be used to power
electrical appliances within 20 feet of the water's
edge.
- In accordance with applicable local codes and the
NEC.
Test GFCIs monthly to assure continued protection.
Infrequently used and portable or cord-connected GFCIs
should be tested before each day's use.
- To test a GFCI:
- Plug a nightlight into the outlet and turn it on.
Press the "TEST" button. Did the light go out? If
not, replace the GFCI.
- Press the "RESET" button. Did the light come back
on? If not, replace the GFCI.
05/14/03
|
|
 |